MINOLTA-QMS MAGICOLOR 3100 DRIVER
The transfer roller or fuser unit may be misinstalled or defective. The accounting No action needed. Reinstall the controller board into the printer. Once reported, our staff will be notified and the comment will be reviewed. The commands are grouped by feature type. These fonts can be printed at a variety of point sizes and in differ- ent styles and resolutions. A consumable is an item that needs to be replaced at regular intervals.
|Date Added:||23 February 2007|
|File Size:||59.74 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Symptom Cause Nothing is Media is jammed printed Cont.
Loading And Printing Glossy Media Label printing is supported only from the multipurpose tray in letter or A4 media sizes. Solution Use uncoated transparency media that is approved for your printer. Lock the transfer cartridge into the printer by pushing down on the base of the tabs until you hear a click. Toner cartridges and other consumables for your printer are available from your local vendor or Q-SHOP www.
Page 26 Yes to reset the consumables usage monitoring system. Symptom Cause Printing takes The printer is set to too much time.
Minolta/QMS Magicolor laser toner cartridges best prices at IJT Direct
All printers, including the magicolorthat are shared on a Windows and higher -based server are automatically made accessible by using the Internet Printer Protocol IPP. Scsi Interface Secure the interface card to the interface panel with the two screws you removed earlier.
The media feed rollers feed media from the media tray s into the printer. Page 99 Remove any magicolr media from the printer. Attach the tray cover back onto the upper media tray.
Page 65 A soft dry cloth or cotton swab to clean the density sensor. Page No User name is required. Solution Remove the imaging unit, and check for damage. The media is picked from the tray, passed under the imaging and transfer units, passed through Automatic Jam Recovery Avoid Loosen the screws and pull the controller board from the printer. Unpack a new fuser unit, lift up both levers c, grip the fuser unit by the levers, align it with the slots in the printer, and slowly lower it d.
A soft dry cloth or cotton swab to clean the density sensor. No User name is required. Duplex 2-sided printing can be done automatically with enough memory installed. Immediately remove the printed trans- parencies from the output tray. Once reported, our staff will be notified and the comment will be reviewed.
Do not overfill the tray. URL is the web address of the file you wish to print to the printer, for example: Close the front cover.
Konica Minolta magicolor 3100 DN – printer – color – laser
Attention Readjust the media guides after inserting the media. Doing so may damage the printer and cause the print quality to deteriorate.
Turn off the printer. The transfer roller or fuser unit may be misinstalled or defective. Opacity refers to how effectively paper blocks out what is written on the opposite side of the page.
Electrical Standby Power saver mode — V Up to 2. Turn off the printer, unplug the power cord, and disconnect all interface cables before cleaning. Media Feeder Max Format. Check the message display to see which color toner is out.